summaryrefslogtreecommitdiff
path: root/target/linux/ar71xx/files/drivers/net/ag71xx/ag71xx_ar7240.c
AgeCommit message (Collapse)Author
2012-01-22ar71xx: move arch specific files to files-2.6.39juhosg
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@29867 3c298f89-4303-0410-b956-a3cf2f4a3e73
2011-12-31ar71xx: ag71xx: implement get_port_{link,stats} callbacksjuhosg
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@29626 3c298f89-4303-0410-b956-a3cf2f4a3e73
2011-12-22ar71xx: set a reserved bit that resets to 1 when writing the address table ↵nbd
control register on the ar7240 switch (should fix #10547) git-svn-id: svn://svn.openwrt.org/openwrt/trunk@29598 3c298f89-4303-0410-b956-a3cf2f4a3e73
2011-12-15ar71xx: ag71xx: fix switch port setup for AR934Xjuhosg
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@29554 3c298f89-4303-0410-b956-a3cf2f4a3e73
2011-12-15ar71xx: ag71xx: allow to connect PHY4 to the CPU on AR934Xjuhosg
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@29553 3c298f89-4303-0410-b956-a3cf2f4a3e73
2011-12-15ar71xx: ag71xx: setup switch interface mode on AR934Xjuhosg
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@29552 3c298f89-4303-0410-b956-a3cf2f4a3e73
2011-12-15ar71xx: ag71xx: detect the built-in switch of the AR934X SoCsjuhosg
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@29551 3c298f89-4303-0410-b956-a3cf2f4a3e73
2011-12-15ar71xx: introduce ar71xx_switch_datajuhosg
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@29549 3c298f89-4303-0410-b956-a3cf2f4a3e73
2011-12-15ar71xx: ag71xx: check PHY IDs before accessing the switch registersjuhosg
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@29541 3c298f89-4303-0410-b956-a3cf2f4a3e73
2011-12-15ar71xx: ag71xx: don't use port 4 of the switch, it is not connected on ar724xjuhosg
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@29540 3c298f89-4303-0410-b956-a3cf2f4a3e73
2011-12-15ar71xx: ag71xx: nuke ar7240sw_initjuhosg
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@29539 3c298f89-4303-0410-b956-a3cf2f4a3e73
2011-11-13ar71xx: ag71xx: add support for getting switch port link statusjuhosg
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@29017 3c298f89-4303-0410-b956-a3cf2f4a3e73
2011-11-08ar71xx: remove dead codenbd
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@28851 3c298f89-4303-0410-b956-a3cf2f4a3e73
2011-11-08ar71xx: on ar7240, exclude ports from their own port vlan destination masknbd
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@28850 3c298f89-4303-0410-b956-a3cf2f4a3e73
2011-07-20ar71xx: reinitialize global switch settings after reset on ar7240nbd
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@27705 3c298f89-4303-0410-b956-a3cf2f4a3e73
2011-07-20ar71xx: configure address aging on ar7240nbd
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@27704 3c298f89-4303-0410-b956-a3cf2f4a3e73
2011-05-17ar71xx: detect link on LAN portsmatteo
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@26922 3c298f89-4303-0410-b956-a3cf2f4a3e73
2011-05-08ar71xx: ag71xx: make switch register access atomicjuhosg
Reading of the PHY registers occasionally returns with bogus values under heavy load. This misleads the PHY driver and thus causes false link/speed change notifications which leads to performance loss. This is easily noticable during an iperf session: ... [ 3] 52.0-53.0 sec 11.3 MBytes 94.4 Mbits/sec [ 3] 53.0-54.0 sec 11.4 MBytes 95.4 Mbits/sec eth1: link down br-lan: port 2(eth1) entering forwarding state eth1: link up (100Mbps/Full duplex) br-lan: port 2(eth1) entering forwarding state br-lan: port 2(eth1) entering forwarding state [ 3] 54.0-55.0 sec 6.75 MBytes 56.6 Mbits/sec [ 3] 55.0-56.0 sec 0.00 Bytes 0.00 bits/sec [ 3] 56.0-57.0 sec 10.5 MBytes 88.1 Mbits/sec ... [ 3] 169.0-170.0 sec 11.4 MBytes 95.4 Mbits/sec [ 3] 170.0-171.0 sec 11.4 MBytes 95.4 Mbits/sec eth1: link up (10Mbps/Half duplex) [ 3] 171.0-172.0 sec 7.63 MBytes 64.0 Mbits/sec [ 3] 172.0-173.0 sec 9.38 MBytes 78.6 Mbits/sec eth1: link up (100Mbps/Full duplex) [ 3] 173.0-174.0 sec 11.3 MBytes 94.4 Mbits/sec [ 3] 174.0-175.0 sec 11.4 MBytes 95.4 Mbits/sec git-svn-id: svn://svn.openwrt.org/openwrt/trunk@26856 3c298f89-4303-0410-b956-a3cf2f4a3e73
2011-05-08ar71xx: ag71xx: fix section mismatch warningsjuhosg
The function __devinit ag71xx_probe() references a function __devexit ag71xx_phy_disconnect(). This is often seen when error handling in the init function uses functionality in the exit path. The fix is often to remove the __devexit annotation of ag71xx_phy_disconnect() so it may be used outside an exit section. The function ag71xx_phy_disconnect() references a function in an exit section. Often the function ag71xx_ar7240_cleanup() has valid usage outside the exit section and the fix is to remove the __devexit annotation of ag71xx_ar7240_cleanup. git-svn-id: svn://svn.openwrt.org/openwrt/trunk@26855 3c298f89-4303-0410-b956-a3cf2f4a3e73
2011-04-02ar71xx: only allow internal access to the ar7240 switch, export the MDIO bus ↵nbd
behind the switch instead git-svn-id: svn://svn.openwrt.org/openwrt/trunk@26393 3c298f89-4303-0410-b956-a3cf2f4a3e73
2010-11-12ar71xx: use pr_* functions in driversjuhosg
Signed-off-by: Arnaud Lacombe <lacombar@gmail.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@23981 3c298f89-4303-0410-b956-a3cf2f4a3e73
2010-11-12ar71xx: return statements does not need parenthesisjuhosg
Signed-off-by: Arnaud Lacombe <lacombar@gmail.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@23979 3c298f89-4303-0410-b956-a3cf2f4a3e73
2010-11-12ar71xx: wrap long linesjuhosg
(build errors has been fixed - juhosg) Signed-off-by: Arnaud Lacombe <lacombar@gmail.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@23977 3c298f89-4303-0410-b956-a3cf2f4a3e73
2010-11-12ar71xx: fix whitespaces nitsjuhosg
(build error has been fixed - juhosg) Signed-off-by: Arnaud Lacombe <lacombar@gmail.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@23975 3c298f89-4303-0410-b956-a3cf2f4a3e73
2010-10-21ar71xx: fix more section mismatchesnbd
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@23575 3c298f89-4303-0410-b956-a3cf2f4a3e73
2010-08-16ar71xx: add a new driver for the ar7240 switch using swconfig.nbd
hooks directly into the ethernet driver, as MAC resets also require switch reinitializations and the switch is part of the cpu core anyway switch only tl-wr741nd (and other devices using this board file, such as tl-wr841nd) over to using this by default, as other devices are still untested fixes #7563 git-svn-id: svn://svn.openwrt.org/openwrt/trunk@22675 3c298f89-4303-0410-b956-a3cf2f4a3e73
generated by cgit v1.2.3 (git 2.39.1) at 2024-10-20 07:59:45 +0000