1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
|
--- a/drivers/net/wireless/b43/b43.h
+++ b/drivers/net/wireless/b43/b43.h
@@ -720,6 +720,7 @@ struct b43_wldev {
bool qos_enabled; /* TRUE, if QoS is used. */
bool hwcrypto_enabled; /* TRUE, if HW crypto acceleration is enabled. */
bool use_pio; /* TRUE if next init should use PIO */
+ int gpiomask; /* GPIO LED mask as a module parameter */
/* PHY/Radio device. */
struct b43_phy phy;
--- a/drivers/net/wireless/b43/main.c
+++ b/drivers/net/wireless/b43/main.c
@@ -76,6 +76,11 @@ MODULE_FIRMWARE("b43/ucode16_mimo.fw");
MODULE_FIRMWARE("b43/ucode5.fw");
MODULE_FIRMWARE("b43/ucode9.fw");
+static int modparam_gpiomask = 0x000F;
+module_param_named(gpiomask, modparam_gpiomask, int, 0444);
+MODULE_PARM_DESC(gpiomask,
+ "GPIO mask for LED control (default 0x000F)");
+
static int modparam_bad_frames_preempt;
module_param_named(bad_frames_preempt, modparam_bad_frames_preempt, int, 0444);
MODULE_PARM_DESC(bad_frames_preempt,
@@ -2560,10 +2565,10 @@ static int b43_gpio_init(struct b43_wlde
& ~B43_MACCTL_GPOUTSMSK);
b43_write16(dev, B43_MMIO_GPIO_MASK, b43_read16(dev, B43_MMIO_GPIO_MASK)
- | 0x000F);
+ | modparam_gpiomask);
mask = 0x0000001F;
- set = 0x0000000F;
+ set = modparam_gpiomask;
if (dev->sdev->bus->chip_id == 0x4301) {
mask |= 0x0060;
set |= 0x0060;
@@ -5084,10 +5089,10 @@ static void b43_print_driverinfo(void)
feat_sdio = "S";
#endif
printk(KERN_INFO "Broadcom 43xx driver loaded "
- "[ Features: %s%s%s%s%s, Firmware-ID: "
+ "[ Features: %s%s%s%s%s, GPIO LED Mask: 0x%04x, Firmware-ID: "
B43_SUPPORTED_FIRMWARE_ID " ]\n",
feat_pci, feat_pcmcia, feat_nphy,
- feat_leds, feat_sdio);
+ feat_leds, feat_sdio, modparam_gpiomask);
}
static int __init b43_init(void)
|
