| Age | Commit message (Expand) | Author |
|---|
| 2007-08-19 | [adm5120] fix ethernet port mapping of the RB133 | juhosg |
| 2007-08-19 | disable romfs, nothing uses it | nbd |
| 2007-08-19 | fix an off-by-one error | nbd |
| 2007-08-18 | cosmetic fix: properly indent source | nico |
| 2007-08-18 | enable use of 8M flash (closes: #2232) | nico |
| 2007-08-18 | fix vlynq initialization (closes: #2135) | nico |
| 2007-08-18 | update ar7 config, disable watchdog for now (closes: #2146) | nico |
| 2007-08-18 | remove useless code from board support (closes: #2164, thanks to Matteo Croce) | nico |
| 2007-08-13 | [adm5120] cleanup patch of the USB driver | juhosg |
| 2007-08-12 | Fix typo (#2210) | florian |
| 2007-08-11 | Addd kernel modules for NTFS (#2181) | florian |
| 2007-08-10 | fix ar7 image installation (patch by sw, fixes #2197) | nbd |
| 2007-08-10 | [adm5120] USB driver fixes | juhosg |
| 2007-08-10 | Revert the command line appending, was causing some devices not to boot | florian |
| 2007-08-10 | ixp4xx-2.6/nslu2: Added support for building 16MB images | rwhitby |
| 2007-08-10 | [adm5120] minor usb driver cleanup | juhosg |
| 2007-08-08 | Fix the bcm96358 PRID | florian |
| 2007-08-08 | Use the dmz led as diagnostic led | florian |
| 2007-08-08 | More rdc fixes, thanks to Daniel Gimpelevich | florian |
| 2007-08-07 | [adm5120] LED driver fixes | juhosg |
| 2007-08-07 | add support for special LED brightness values | juhosg |
| 2007-08-07 | These patches moved to generic-2.6 | florian |
| 2007-08-07 | Remove the eeprom patches, but move the git-newsetup to generic, so that the ... | florian |
| 2007-08-07 | Also add eeprom 93cx6 to generic-2.6 | florian |
| 2007-08-07 | Update rdc-2.6 description and fix the firmware for sitecom devices | florian |
| 2007-08-07 | Fix the gpio handling and flash resource declaration, thanks to Daniel Gimpel... | florian |
| 2007-08-07 | Enable kexec for x86 as well (#2141) | florian |
| 2007-08-07 | Revert 8353, can cause more bad than good | florian |
| 2007-08-07 | build system cleanup/restructuring as described in http://lists.openwrt.org/p... | nbd |
| 2007-08-06 | Prevent the ioctl from handling even unsupported ioctls | florian |
| 2007-08-06 | Allow rdc-2.6 to kexec | florian |
| 2007-08-06 | More led driver fixes | florian |
| 2007-08-06 | Remove the LED code from the network driver | florian |
| 2007-08-06 | Still broken for now | florian |
| 2007-08-06 | More rdc-2.6 fixes by Daniel Gimpelevich, thanks ! | florian |
| 2007-08-06 | Put back some code from the 2.4 driver, supposed to boot network perfs | florian |
| 2007-08-06 | Disable NAPI by default (#1671) | florian |
| 2007-08-06 | [adm5120] add special values for GPIO lines in switch | juhosg |
| 2007-08-06 | Add generic gpio support to rdc, convert the led driver to be a platform driv... | florian |
| 2007-08-05 | added improved watchdog driver for amazon | blogic |
| 2007-08-05 | cleaned up amazon serial and prom code | blogic |
| 2007-08-04 | removed volatile register derefs from amazon setup code | blogic |
| 2007-08-04 | rewrite of the amazon irq code | blogic |
| 2007-08-03 | [adm5120] fix reset function in USB driver | juhosg |
| 2007-08-03 | [adm5120] USB driver fixes | juhosg |
| 2007-08-03 | Make jffs2 images work with rdc, add a sitecom wl-153 profile and kernel conf... | florian |
| 2007-08-02 | Some adm5120-hcd cleanups | florian |
| 2007-08-02 | Add a zyxel prestige profile for the adm5120eb target, build the hcd driver a... | florian |
| 2007-08-02 | [adm5120] add definitions for RouterBOARD 150, no NAND driver yet | juhosg |
| 2007-08-01 | [adm5120] add support for board specific vlan matrix, should fix #2132 | juhosg |
