Age | Commit message (Collapse) | Author |
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@18657 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
config on first boot, this will be removed at some point in the future
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@18432 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
consistent accross platforms
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@18425 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
This patch is out of broadcoms official source code
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@18413 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@18367 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
Gimpelevich
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@18253 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@18214 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
Signed-off-by: Roger Hardiman <roger@rjh.org.uk>
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@17598 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
kernelversion in other targets' Target-Name
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@17102 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@17074 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@17031 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
(forgotten in #5186)
Closes #5333
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@16448 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@16144 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@16139 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@15944 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
kernel
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@15440 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@15242 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
busybox - we always use -l on telnetd anyway
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@15097 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@15045 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
driver work (#1862)
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@14891 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
Here is support for the compact Asus WL-330gE. It uses that all-in-one
5354 Broadcom chip that's also in the WL-520gU, so I assume USB
support can be soldered on. I've yet to open up the device, though.
Initial flashing is done through the CFE failsafe mode like on other
Asus devices, where you boot holding the reset button, the power LED
flashes, and you tftp an image.
Signed-off-by: David Cooper <dave@kupesoft.com>
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@14624 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@13955 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
throughput and cpu load improvement)
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@13946 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
netfilter), upgrade it from minor version .2 to .3 (adds fixed bssid support for ad-hoc)
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@13912 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@13819 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
make mtd refresh based config append optional (leave enabled on x86)
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@12657 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@12499 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@12276 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
configuration (closes #2788)
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@11935 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@11909 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
re-based against 2.4.35 and repaired for obvious breakage (didn't use
its device table, etc.).
Changes from Linksys tree:
- Remove 'vendor' and 'product' parameters; these aren't used in the
mainstream driver and seem to only have served to break it.
- Remove bogus 'sierra_device_ids' table, used with above.
- Changed references to 'sierra_device_ids' back to id_table
- Changed non-standard CONFIG_USB_SERIAL_SIERRA_3G (line 886) to
current module standard CONFIG_USB_SERIAL_SIERRAWIRELESS
- Added #include to enable pl2303 hack to remain until I can figure
out if it's still necessary.
Signed-off-by: RB <aoz.syn@gmail.com>
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@11899 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
supported platforms (WRT54G3G) by adding direct support for the Sierra
Wireless 3G modems.
Signed-off-by: RB <aoz.syn@gmail.com>
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@11898 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
I noticed my wrt350n would not reliably reboot after entering
the reboot command. I found this code in the source for the
wrt600n. It corrects the problem, and the wrt350n reboots
reliably now.
Signed-off-by: Ben Pfountz <netprince (at) vt (dot) edu>
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@11470 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
This patch allows the bcm57xx module to work correctly with failsafe mode.
insmod doesn't return an error when a module loads but doesn't detect a switch.
I added the check_module function to load the module, then make sure
it doesn't just exit immediately. This allows preinit to only attempt to
load the bcm57xx module when switch-robo and switch-adm dont detect a switch.
The activate_gpio parameter to bcm57xx simply instructs the module to attempt
to activate the switch via gpio before probing for the switch.
Tested on wrt350n.
Signed-off-by: Ben Pfountz <netprince (at) vt (dot) edu>
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@11468 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
Update the netconfig script to support boardtype 0x478. I've tested this
on the wrt350n, hopefully it will match the 600n as well.
Signed-off-by: Ben Pfountz <netprince (at) vt (dot) edu>
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@11467 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@11340 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@11275 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@11214 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
Pfountz <netprince@vt.edu>
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@11070 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@10695 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@10694 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@10693 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@10205 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@10142 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
broadcom-wl to a contributed version (v4.150.10.5) - no bcm57xx support yet, will follow shortly
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@10137 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@10097 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@9684 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
further
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@9556 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@9533 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@9523 3c298f89-4303-0410-b956-a3cf2f4a3e73
|