Age | Commit message (Collapse) | Author |
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@13955 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
throughput and cpu load improvement)
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@13946 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
netfilter), upgrade it from minor version .2 to .3 (adds fixed bssid support for ad-hoc)
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@13912 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@13819 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
make mtd refresh based config append optional (leave enabled on x86)
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@12657 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@12499 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@12276 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
configuration (closes #2788)
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@11935 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@11909 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
re-based against 2.4.35 and repaired for obvious breakage (didn't use
its device table, etc.).
Changes from Linksys tree:
- Remove 'vendor' and 'product' parameters; these aren't used in the
mainstream driver and seem to only have served to break it.
- Remove bogus 'sierra_device_ids' table, used with above.
- Changed references to 'sierra_device_ids' back to id_table
- Changed non-standard CONFIG_USB_SERIAL_SIERRA_3G (line 886) to
current module standard CONFIG_USB_SERIAL_SIERRAWIRELESS
- Added #include to enable pl2303 hack to remain until I can figure
out if it's still necessary.
Signed-off-by: RB <aoz.syn@gmail.com>
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@11899 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
supported platforms (WRT54G3G) by adding direct support for the Sierra
Wireless 3G modems.
Signed-off-by: RB <aoz.syn@gmail.com>
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@11898 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
I noticed my wrt350n would not reliably reboot after entering
the reboot command. I found this code in the source for the
wrt600n. It corrects the problem, and the wrt350n reboots
reliably now.
Signed-off-by: Ben Pfountz <netprince (at) vt (dot) edu>
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@11470 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
This patch allows the bcm57xx module to work correctly with failsafe mode.
insmod doesn't return an error when a module loads but doesn't detect a switch.
I added the check_module function to load the module, then make sure
it doesn't just exit immediately. This allows preinit to only attempt to
load the bcm57xx module when switch-robo and switch-adm dont detect a switch.
The activate_gpio parameter to bcm57xx simply instructs the module to attempt
to activate the switch via gpio before probing for the switch.
Tested on wrt350n.
Signed-off-by: Ben Pfountz <netprince (at) vt (dot) edu>
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@11468 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
Update the netconfig script to support boardtype 0x478. I've tested this
on the wrt350n, hopefully it will match the 600n as well.
Signed-off-by: Ben Pfountz <netprince (at) vt (dot) edu>
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@11467 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@11340 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@11275 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@11214 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
Pfountz <netprince@vt.edu>
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@11070 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@10695 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@10694 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@10693 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@10205 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@10142 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
broadcom-wl to a contributed version (v4.150.10.5) - no bcm57xx support yet, will follow shortly
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@10137 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@10097 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@9684 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
further
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@9556 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@9533 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@9523 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@9494 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@9069 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@9015 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@8949 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@8848 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@8718 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@8695 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
override many target settings, including arch - merge adm5120, adm5120eb. target profiles still need to be adapted for subtargets
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@8694 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@8690 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@8654 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
(the -2.4 will be included in the board name here). CONFIG_LINUX_<ver>_<board> becomes CONFIG_TARGET_<board>, same for profiles.
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@8653 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@8483 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@8482 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@8450 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
http://lists.openwrt.org/pipermail/openwrt-devel/2007-August/001159.html
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@8362 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
the moment
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@7870 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
atheros as well as soon as i've added support for it
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@7810 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
related bugs (#1888)
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@7731 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@7722 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@7623 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@7622 3c298f89-4303-0410-b956-a3cf2f4a3e73
|