summaryrefslogtreecommitdiff
path: root/target/linux/ar71xx
AgeCommit message (Expand)Author
2010-03-07ar71xx: make the rb4xx nand driver depends on AR71XX_MACH_RB4XXjuhosg
2010-03-07ar71xx: rename mach-rb-4xx.c to mach-rb4xx.c, and change Kconfig symboljuhosg
2010-03-05ar71xx: don't init PCI irqs on the AR7240 if the PCIe subsystem are in resetjuhosg
2010-03-05ar71xx: fix sysupgrade on the WRT400N (thanks to chuljin)juhosg
2010-03-05ar71xx: fix status led detection on the RB4xx boardsjuhosg
2010-03-05ar71xx: ag71xx: move calling ag71xx_phy_stop out from spinlockjuhosg
2010-03-05ar71xx: ag71xx: move link update functionjuhosg
2010-03-05ar71xx: ag71xx: don't use dev->trans_startjuhosg
2010-03-05ar71xx: ag71xx: use dma_unmap_single to unmap framesjuhosg
2010-03-03ar71xx: restore command line on 2.6.33juhosg
2010-03-03ar71xx: sync 2.6.33 configjuhosg
2010-03-03ar71xx: refresh 2.6.33 patchesjuhosg
2010-03-02ar71xx: ag71xx: use correct device pointer for dma_map_singlejuhosg
2010-03-02ar71xx: ag71xx: don't use virt_to_physjuhosg
2010-03-02ar71xx: ag71xx: simplify register access functionsjuhosg
2010-03-02ar71xx: ag71xx: use NETDEV_TX_OKjuhosg
2010-03-02ar71xx: use COMMAND_LINE_SIZEjuhosg
2010-03-01ar71xx: add default network configuration file for the TL-WR741ND boardjuhosg
2010-03-01ar71xx: add default network configuration file for the DIR-600 rev. A1 boardjuhosg
2010-03-01ar71xx: register DSA switch for the AP91 based boardsjuhosg
2010-03-01ar71xx: add DSA driver for the AR7240 built-in ethernet switchjuhosg
2010-03-01ar71xx: add QinQ tagging format for the DSA driverjuhosg
2010-02-28ar71xx: 2.6.33 patchesmatteo
2010-02-28kernel: update to kernel 2.6.32.9hauke
2010-02-24ar71xx: select vsc73x5 microcode in the AP83/PB44 profilesjuhosg
2010-02-24ar71xx: refresh ksz8041 patchjuhosg
2010-02-24ar71xx: add default network configuration file for the TL-WR1043ND boardjuhosg
2010-02-24ar71xx: register RTL8366RB switch on the TL-WR1043NB boardjuhosg
2010-02-24ar71xx: enable the RTL8366RB driverjuhosg
2010-02-24ar71xx: fix pll value for the eth0 interface on the TL-WR1043ND boardjuhosg
2010-02-24ar71xx: remove an accidentally committed patchjuhosg
2010-02-24ar71xx: enable TX/RX flow control on the AR7240juhosg
2010-02-24ar71xx: use the correct name for the status LED on the WRT400 boardjuhosg
2010-02-24ar71xx: update default network configuration file for the WNDR3700juhosg
2010-02-19ar71xx: fix mac addresses on the DIR-600 rev. A1 boardjuhosg
2010-02-19ar71xx: fix wireless mac address on the TL-WR741NDjuhosg
2010-02-19ar71xx: move AP91 specific ethernet initialization into a separate filejuhosg
2010-02-19ar71xx: create firmware images for the TL-WR941ND v4 boardjuhosg
2010-02-19ar71xx: sync kernel configjuhosg
2010-02-19ar71xx: add uci configuration for the WAN LED on the WNDR3700juhosg
2010-02-19ar71xx: add missing GPIO LED for the WNDR3700 boardjuhosg
2010-02-19ar71xx: fix polarity of GPIO buttons on the WNDR3700 boardjuhosg
2010-02-12update kernel from 2.6.32.7 to 2.6.32.8, thanks tripolarthepeople
2010-02-11clean up handling of some kernel symbolskaloz
2010-02-11re-sort all target and subtarget config fileskaloz
2010-02-10ar71xx: fix WLAN mac address on the TL-WR1043NDjuhosg
2010-02-09ar71xx: enable CFI probe for the WZR-HP-G300NHjuhosg
2010-02-09ar71xx: sync kernel configjuhosg
2010-02-09ar71xx/mac80211: add a workaround for the bad signal strength on the WNDR3700juhosg
2010-02-08kernel: 2.6.32: integrate m25p80 driver related patches from ar71xxjuhosg
generated by cgit v1.2.3 (git 2.39.1) at 2024-11-15 22:30:41 +0000