summaryrefslogtreecommitdiff
path: root/target/linux/ar71xx/files
AgeCommit message (Expand)Author
2011-08-04ar71xx: fix ethernet FIFO state corruption on ar7240nbd
2011-08-04ag71xx: fix memory corruption issues on ar7240 on ethernet start/stopnbd
2011-08-04ar71xx: fix MAC/MDIO reset mask handlingnbd
2011-07-28ar71xx: merge WZR-HP-G301NH support into WZR-HP-G300NHjogo
2011-07-24ar71xx: autodetect rtl8366s/rtl8366rb on wzr-hp-g300nhnbd
2011-07-24rtl8366: unify rtl8366s and rtl8366rb platform datanbd
2011-07-24ar71xx: enable the usb power regulator on the wzr-hp-ag300h through gpio 2 (#...nbd
2011-07-20ar71xx: reinitialize global switch settings after reset on ar7240nbd
2011-07-20ar71xx: configure address aging on ar7240nbd
2011-07-20ar71xx: reset the phy in the ethernet init on ar724xnbd
2011-07-20ar71xx: make sure that rx and interrupts are disabled before issuing the hard...nbd
2011-07-20ar71xx: increase the delay after the ethernet MAC resetnbd
2011-07-20ar71xx: fix an unused variable warningnbd
2011-07-09ar71xx: do not reset the hardware on transmit timeout - this would mess up th...nbd
2011-07-09ag71xx: keep the rx engine stopped while the link is not up, should hopefully...nbd
2011-06-30ar71xx: remove CONFIG_MTD_CONCAT ifdefs from the WZR-HP-AG300H codejuhosg
2011-06-29ar71xx: merge 2.6.39 patchesjuhosg
2011-06-29ar71xx: add 2.6.39 supportjuhosg
2011-06-29ar71xx: remove ar71xx_gpio_irq_set_typejuhosg
2011-06-29ar71xx: add separate handlers for IP3 interruptsjuhosg
2011-06-29ar71xx: use separate handlers for IP2 interruptsjuhosg
2011-06-29ar71xx: remove useless irq_desc.status initializationsjuhosg
2011-06-25ar71xx: bring up secondary radio on wzr-hp-ag300h (fixes #9608)nbd
2011-06-19ar71xx: cleanup AR933X UART driverjuhosg
2011-06-19ar71xx: fix uart clock frequency for AR933Xjuhosg
2011-06-13ar71xx: use ar933x_uart.h in the AR933X serial driverjuhosg
2011-06-13ar71xx: update early_printk codejuhosg
2011-06-04ar71xx: setup wdt_clock for AR913X to avoid a kernel bugjuhosg
2011-06-04ar71xx: select the internal antenna by default on the ZCN-1523H boardsjuhosg
2011-06-01Revert "ar71xx: only enable the rx engine after the link is up..."nbd
2011-06-01ar71xx: init external_reset for AR933Xjuhosg
2011-06-01ar71xx: add external_reset field to ath9k_platform_datajuhosg
2011-06-01ar71xx: init get_mac_revision on AR9330 rev 1juhosg
2011-06-01ar71xx: add get_mac_revision to ath9k_platform_datajuhosg
2011-06-01ar71xx: export SoC revisionjuhosg
2011-06-01ar71xx: add kernel support for the buffalo wzr-hp-ag300hnbd
2011-05-31ar71xx: add support for the AP121/AP121-MINI reference boardsjuhosg
2011-05-31ar71xx: register UART for the AR933X SoCsjuhosg
2011-05-31ar71xx: add serial driver for the AR933X UARTjuhosg
2011-05-31ar71xx: add WMAC initialization code for the AR933X SoCsjuhosg
2011-05-31ar71xx: add ethernet initialization for the AR933X SoCsjuhosg
2011-05-31ar71xx: enable USB support for the AR933x SoCsjuhosg
2011-05-31ar71xx: add AR933x specific glue for ar71xx_device{start,stop}juhosg
2011-05-31ar71xx: the watchdog uses the reference clock on the AR933x SoCsjuhosg
2011-05-31ar71xx: add AR933x specific glue code for IRQ initializationjuhosg
2011-05-31ar71xx: don't register 8250 UART on the AR933x SoCsjuhosg
2011-05-31ar71xx: enable GPIO support for the AR933x SoCsjuhosg
2011-05-31ar71xx: add AR933x specific frequency initialization codejuhosg
2011-05-31ar71xx: add AR933x specific early_printk supportjuhosg
2011-05-31ar71xx: add preliminary support for the Atheros AR933x SoCsjuhosg
generated by cgit v1.2.3 (git 2.39.1) at 2024-11-02 15:31:44 +0000