summaryrefslogtreecommitdiff
path: root/target/linux/ar71xx/files/drivers/net
AgeCommit message (Expand)Author
2012-04-29ar71xx: allow to disable link polling on unused PHYsjuhosg
2012-04-25ar71xx: enable MIB counters in the built-in switch of the AR934xjuhosg
2012-03-15ar71xx: move micrel PHY driver to the generic linux targetjuhosg
2012-03-13ar71xx: ag71xx: fix ARP frame reception on AR934x switch portsjuhosg
2012-03-13ar71xx: ag71xx: start aneg on switch PHYs after resetjuhosg
2012-03-13ar71xx: ag71xx: poll PHY status of all available switch portsjuhosg
2012-03-13ar71xx: ag71xx: allow to use port 5 of the AR934x built-in switchjuhosg
2012-03-07ar71xx: ag71xx: fix get_port_link callbackjuhosg
2012-03-07ar71xx: ag71xx: use the generic get_port_link implementationjuhosg
2012-03-01ar71xx: ag71xx: keep VLAN tags if VLAN is not enabledjuhosg
2012-02-10ar71xx: ag71xx: add BQL supportjuhosg
2012-02-10ar71xx: add preliminary support for 3.3juhosg
2012-02-10ar71xx: merge files-3.2 to filesjuhosg
2012-01-22ar71xx: move arch specific files to files-2.6.39juhosg
2012-01-22ar71xx: include linux/module.h in the micrel phy driverjuhosg
2011-12-31ar71xx: ag71xx: implement get_port_{link,stats} callbacksjuhosg
2011-12-22ar71xx: set a reserved bit that resets to 1 when writing the address table co...nbd
2011-12-15ar71xx: ag71xx: fix switch port setup for AR934Xjuhosg
2011-12-15ar71xx: ag71xx: allow to connect PHY4 to the CPU on AR934Xjuhosg
2011-12-15ar71xx: ag71xx: setup switch interface mode on AR934Xjuhosg
2011-12-15ar71xx: ag71xx: detect the built-in switch of the AR934X SoCsjuhosg
2011-12-15ar71xx: introduce ar71xx_switch_datajuhosg
2011-12-15ar71xx: ag71xx: check PHY IDs before accessing the switch registersjuhosg
2011-12-15ar71xx: ag71xx: don't use port 4 of the switch, it is not connected on ar724xjuhosg
2011-12-15ar71xx: ag71xx: nuke ar7240sw_initjuhosg
2011-11-13ar71xx: ag71xx: add support for getting switch port link statusjuhosg
2011-11-13ar71xx: ag71xx: remove unused mii_ctrl field from struct ag71xxjuhosg
2011-11-13ar71xx: ag71xx: remove unused mii_cfg related functions and definesjuhosg
2011-11-13ar71xx: set MII interface speed from the set_speed callbacksjuhosg
2011-11-13ar71xx: rename set_pll callback to set_speed in ag71xx_platform_datajuhosg
2011-11-13ar71xx: ag71xx: remove MII interface setup codejuhosg
2011-11-12ar71xx: ag71xx: use fixed link parameters if the mii bus is not registeredjuhosg
2011-11-08ar71xx: remove dead codenbd
2011-11-08ar71xx: on ar7240, exclude ports from their own port vlan destination masknbd
2011-10-08ag71xx: close a race between the phy state machine and link statejogo
2011-09-11ar71xx: fix register range check for DMA stuck checks (thx, Frédéric Moulins)nbd
2011-08-13ar71xx: add some code to detect DMA stuck conditions on ar7240nbd
2011-08-13ar71xx: on ar724x only reset the link status in the restart handler, the fast...nbd
2011-08-04ar71xx: fix ethernet FIFO state corruption on ar7240nbd
2011-08-04ag71xx: fix memory corruption issues on ar7240 on ethernet start/stopnbd
2011-08-04ar71xx: fix MAC/MDIO reset mask handlingnbd
2011-07-20ar71xx: reinitialize global switch settings after reset on ar7240nbd
2011-07-20ar71xx: configure address aging on ar7240nbd
2011-07-20ar71xx: reset the phy in the ethernet init on ar724xnbd
2011-07-20ar71xx: make sure that rx and interrupts are disabled before issuing the hard...nbd
2011-07-20ar71xx: increase the delay after the ethernet MAC resetnbd
2011-07-20ar71xx: fix an unused variable warningnbd
2011-07-09ar71xx: do not reset the hardware on transmit timeout - this would mess up th...nbd
2011-07-09ag71xx: keep the rx engine stopped while the link is not up, should hopefully...nbd
2011-06-01Revert "ar71xx: only enable the rx engine after the link is up..."nbd
generated by cgit v1.2.3 (git 2.46.0) at 2024-12-27 15:29:41 +0000