summaryrefslogtreecommitdiff
path: root/target/linux/ar71xx/files/drivers/net
AgeCommit message (Expand)Author
2011-12-22ar71xx: set a reserved bit that resets to 1 when writing the address table co...nbd
2011-12-15ar71xx: ag71xx: fix switch port setup for AR934Xjuhosg
2011-12-15ar71xx: ag71xx: allow to connect PHY4 to the CPU on AR934Xjuhosg
2011-12-15ar71xx: ag71xx: setup switch interface mode on AR934Xjuhosg
2011-12-15ar71xx: ag71xx: detect the built-in switch of the AR934X SoCsjuhosg
2011-12-15ar71xx: introduce ar71xx_switch_datajuhosg
2011-12-15ar71xx: ag71xx: check PHY IDs before accessing the switch registersjuhosg
2011-12-15ar71xx: ag71xx: don't use port 4 of the switch, it is not connected on ar724xjuhosg
2011-12-15ar71xx: ag71xx: nuke ar7240sw_initjuhosg
2011-11-13ar71xx: ag71xx: add support for getting switch port link statusjuhosg
2011-11-13ar71xx: ag71xx: remove unused mii_ctrl field from struct ag71xxjuhosg
2011-11-13ar71xx: ag71xx: remove unused mii_cfg related functions and definesjuhosg
2011-11-13ar71xx: set MII interface speed from the set_speed callbacksjuhosg
2011-11-13ar71xx: rename set_pll callback to set_speed in ag71xx_platform_datajuhosg
2011-11-13ar71xx: ag71xx: remove MII interface setup codejuhosg
2011-11-12ar71xx: ag71xx: use fixed link parameters if the mii bus is not registeredjuhosg
2011-11-08ar71xx: remove dead codenbd
2011-11-08ar71xx: on ar7240, exclude ports from their own port vlan destination masknbd
2011-10-08ag71xx: close a race between the phy state machine and link statejogo
2011-09-11ar71xx: fix register range check for DMA stuck checks (thx, Frédéric Moulins)nbd
2011-08-13ar71xx: add some code to detect DMA stuck conditions on ar7240nbd
2011-08-13ar71xx: on ar724x only reset the link status in the restart handler, the fast...nbd
2011-08-04ar71xx: fix ethernet FIFO state corruption on ar7240nbd
2011-08-04ag71xx: fix memory corruption issues on ar7240 on ethernet start/stopnbd
2011-08-04ar71xx: fix MAC/MDIO reset mask handlingnbd
2011-07-20ar71xx: reinitialize global switch settings after reset on ar7240nbd
2011-07-20ar71xx: configure address aging on ar7240nbd
2011-07-20ar71xx: reset the phy in the ethernet init on ar724xnbd
2011-07-20ar71xx: make sure that rx and interrupts are disabled before issuing the hard...nbd
2011-07-20ar71xx: increase the delay after the ethernet MAC resetnbd
2011-07-20ar71xx: fix an unused variable warningnbd
2011-07-09ar71xx: do not reset the hardware on transmit timeout - this would mess up th...nbd
2011-07-09ag71xx: keep the rx engine stopped while the link is not up, should hopefully...nbd
2011-06-01Revert "ar71xx: only enable the rx engine after the link is up..."nbd
2011-05-31ar71xx: ag71xx: make ring sizes configurable via ethtooljuhosg
2011-05-31ar71xx: ag71xx: prepare to make ring sizes configurablejuhosg
2011-05-31ar71xx: ag71xx: nuke unused AG71XX_TX_FIFO_LEN definejuhosg
2011-05-30ar71xx: only enable the rx engine after the link is up, fixes a race conditio...nbd
2011-05-30ar71xx: disable flow control for ar724x, it can get stuck in a loop of contin...nbd
2011-05-17ar71xx: detect link on LAN portsmatteo
2011-05-14use correct macros and frame size in ag71xxmatteo
2011-05-08ar71xx: ag71xx: make switch register access atomicjuhosg
2011-05-08ar71xx: ag71xx: fix section mismatch warningsjuhosg
2011-05-08ar71xx: ag71xx: fix build error if debugfs is enabledjuhosg
2011-05-07ar71xx: ag71xx: add debugfs entry for [rt]x_ringjuhosg
2011-05-07ar71xx: ag71xx: add timestamps to ag71xx_bufjuhosg
2011-05-07ar71xx: ag71xx: use dynamically allocated buffer for napi_statsjuhosg
2011-05-07ar71xx: ag71xx: use debugfs_remove_recursivejuhosg
2011-04-02ar71xx: only allow internal access to the ar7240 switch, export the MDIO bus ...nbd
2011-04-02ar71xx: frequent ethernet mac resets upset the MDIO bus on ar7240, so do not ...nbd