summaryrefslogtreecommitdiff
path: root/target/linux/ar71xx/config-2.6.39
AgeCommit message (Collapse)Author
2012-02-08ar71xx: add support for the TRENDNet TEW-673GRU boardjuhosg
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@30376 3c298f89-4303-0410-b956-a3cf2f4a3e73
2012-01-31ar71xx: merge DIR-600 A1 and DIR-615 E4 supportjuhosg
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@29976 3c298f89-4303-0410-b956-a3cf2f4a3e73
2012-01-31ar71xx: support for D-LINK DIR-615 rev. E4juhosg
This patch adds support for D-LINK DIR-615 E4 board. It's mostly based on the existing support for DIR-600 A1, with some changes in the leds configuration. It's an updated version of the patch that reliably works on my hw for about a year (it was built from trunk on Jan 2011). When I decided to update the firmware and checked for the current support for that device, I also found previously posted patches by Alexey Loukianov that mentioned some stability issues. I'm not sure where could be the difference, the patches are very similar except the wmac led pin number - I was using 1, and those patches used 17. [juhosg: add 3.2 support] Signed-off-by: Vadim Girlin <vadimgirlin@gmail.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@29973 3c298f89-4303-0410-b956-a3cf2f4a3e73
2012-01-31ar71xx: add support for TP-Link TL-MR11Ujuhosg
Adds support for TL-MR11U, a portable router with very similar hardware to the TL-WR703N and TL-MR3020, but with an onboard 2000mAh battery. Tested, working: All interfaces (Ethernet, 802.11n, USB) WPS & Reset switches (Power appears to be a hardware slider) Ethernet, Wifi, 3G LEDs (Power & charging LEDs hardware controlled) Sysupgrade [juhosg: fix indentations to use TABs instead of spaces, fix 3.2 patch breakage] Signed-off-by: Simon Taylor <simon.taylor.uk@gmail.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@29972 3c298f89-4303-0410-b956-a3cf2f4a3e73
2012-01-28[ar71xx] add support for the Atheros AP113 reference boardflorian
This reference board is equipped with: - AR7242 SoC - AR9580 on-board Wi-Fi - AR8316 switch git-svn-id: svn://svn.openwrt.org/openwrt/trunk@29935 3c298f89-4303-0410-b956-a3cf2f4a3e73
2012-01-26ar71xx: add support for Compex WPE72/WPE72NXjuhosg
This patch adds support for Compex WPE72 bare board and Compex WPE72NX Indoor Access Point. [juhosg: add support to 3.2 as well] Signed-off-by: Johnathan Boyce <jon.boyce@globalreach.eu.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@29912 3c298f89-4303-0410-b956-a3cf2f4a3e73
2012-01-07ar71xx: add initial support for the TL-WR2543N/ND boardjuhosg
The WLAN LEDs are not working yet. git-svn-id: svn://svn.openwrt.org/openwrt/trunk@29680 3c298f89-4303-0410-b956-a3cf2f4a3e73
2012-01-07generic: improve MIPS kexec supportjuhosg
It is based on patches from the linux-longsoon-community git tree: http://dev.lemote.com/cgit/linux-loongson-community.git/ Now the kernel can use the command line parameter from kexec-tools. Runtime tested on ar71xx with 2.6.39.4 (the wathdog must be stopped before executing the new kernel). Compile tested with lantiq (3.1.4) and brcm47xx (3.0.12). git-svn-id: svn://svn.openwrt.org/openwrt/trunk@29674 3c298f89-4303-0410-b956-a3cf2f4a3e73
2012-01-06ar71xx: add support for Redwave RW2458Njuhosg
Signed-off-by: Cezary Jackiewicz <cezary.jackiewicz@gmail.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@29669 3c298f89-4303-0410-b956-a3cf2f4a3e73
2012-01-04ar71xx: add inital support for the ALFA Network AP96 boardjuhosg
The microSD slot and the Real Time Clock is not working yet. The miniPCIe interface is not tested due to the lack of a suitable card. git-svn-id: svn://svn.openwrt.org/openwrt/trunk@29662 3c298f89-4303-0410-b956-a3cf2f4a3e73
2012-01-04ar71xx: add support for TP-Link TL-MR3020juhosg
This patch adds support for the TP-Link device TL-MR3020 which is very similiar to the TL-WR703N. The TL-MR3020 uses 5 LEDs, 1 push button and a switch with 3 positions. Only four LEDs can be controlled via GPIO. The power LED is connected to the power supply. The WPS push button has been mapped to KEY_WPS_BUTTON. The two GPIO signals of the sliding switch have been mapped to BTN_0 and BTN_1. I have also setup a wiki page with details here: http://wiki.openwrt.org/toh/tp-link/tl-mr3020 USB is working and has been tested with USB mass storage and USB UMTS stick. Wifi also seems to work. Ethernet is working too. Signed-off-by: Christian Cier-Zniewski <c.cier@gmx.de> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@29651 3c298f89-4303-0410-b956-a3cf2f4a3e73
2012-01-01ar71xx: add support for the ALFA Network N2/N5 boardsjuhosg
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@29635 3c298f89-4303-0410-b956-a3cf2f4a3e73
2011-12-31ar71xx: enable SWCONFIG_LEDSjuhosg
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@29630 3c298f89-4303-0410-b956-a3cf2f4a3e73
2011-12-18ar71xx: add support for the wzr-hp-g300nh2nbd
Signed-off-by: Mark Deneen <mdeneen@gmail.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@29567 3c298f89-4303-0410-b956-a3cf2f4a3e73
2011-12-14ar71xx: add support for ALFA Network's Hornet-UB boardjuhosg
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@29535 3c298f89-4303-0410-b956-a3cf2f4a3e73
2011-12-05ar71xx: add preliminary support for wzr-hp-g450hnbd
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@29441 3c298f89-4303-0410-b956-a3cf2f4a3e73
2011-12-03ar71xx: add mtd partition parser for the TP-Link boardsjuhosg
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@29415 3c298f89-4303-0410-b956-a3cf2f4a3e73
2011-11-07ar71xx: enable WHR-HP-G300N support in kernel configjuhosg
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@28801 3c298f89-4303-0410-b956-a3cf2f4a3e73
2011-11-01ar71xx: add initial support for the TL-WR741ND v4 boardjuhosg
The ethernet port LEDs are not working yet. git-svn-id: svn://svn.openwrt.org/openwrt/trunk@28706 3c298f89-4303-0410-b956-a3cf2f4a3e73
2011-10-27ar71xx: add initial support for the OpenMesh OM2P boardjuhosg
Based on a patch by Marek Lindner <marek@open-mesh.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@28617 3c298f89-4303-0410-b956-a3cf2f4a3e73
2011-10-24ar71xx: Buffalo WHR-HP-G300N kernel supportjuhosg
The initial support for the Buffalo WHR-HP-G300N box. The code was confirmed to boot and run, but not tested in depth. Known problem: iw phy phy0 info shows: Coverage class: 0 (up to 0m) Available Antennas: TX 0 RX 0 Signed-off-by: Yoichi Shinoda <shinoda@jaist.ac.jp> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@28567 3c298f89-4303-0410-b956-a3cf2f4a3e73
2011-10-24ar71xx: add kernel support for the Allnet ALL0258N boardjuhosg
This patchs adds support for the Allnet ALL0258N outdoor AP/bridge. The ALL0258N is based on the AR7240 SoC paired with an AR9285 radio, it got 8MB of NOR and 32MB SDRAM. Signed-off-by: Daniel Golle <dgolle@allnet.de> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@28564 3c298f89-4303-0410-b956-a3cf2f4a3e73
2011-10-24ar71xx: don't override CONFIG_FSNOTIFYjuhosg
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@28563 3c298f89-4303-0410-b956-a3cf2f4a3e73
2011-09-21ar71xx: add support for the TP-Link TL-WR703N v1 boardjuhosg
Based on a patch by dongyuqi <729650915@qq.com> git-svn-id: svn://svn.openwrt.org/openwrt/trunk@28277 3c298f89-4303-0410-b956-a3cf2f4a3e73
2011-06-29ar71xx: add 2.6.39 supportjuhosg
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@27310 3c298f89-4303-0410-b956-a3cf2f4a3e73
generated by cgit v1.2.3 (git 2.46.0) at 2024-12-28 06:07:59 +0000