Age | Commit message (Collapse) | Author |
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20121 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20120 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20119 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
description
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20118 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
targets
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20117 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20116 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
frames (thanks to Duy Nguyen for pointing this out)" again
It appears to be causing trouble at least with some clients.
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20115 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
(thanks to Duy Nguyen for pointing this out)
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20114 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20113 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20110 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20108 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
sometimes an interface does not get added to the bridge properly
this seems to be a race of interface setup vs wpa_supplicant
fix this by configuring the interface only after wpa_supplicant has been started
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20106 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
bridge - it suffers from race conditions. instead let hostapd add the interfaces to the bridge
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20104 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20103 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20099 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
* Thanks to Eugeny Zadevalov
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20098 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20097 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20096 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20095 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20094 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20093 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20092 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20091 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20090 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
hostapd startup
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20089 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20088 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20087 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20086 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
same package
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20085 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20084 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
* Create defines for some magic values/masks.
* Change vlan_id to u16, to allow VIDs > 255.
* Add a range check to set_pvid as it isn't a VID, but the index
in the vlan table.
* Set the max VID to 4094, since 4095 is a reserved value and
should not be used.
* In mangle_rx replace the provided VID with the VID of the table
entry of the port, not the index of the table.
* In hw_apply, remove a redundant emptyness check (was already
checked several lines above).
* In no vlan mode do not set the ingress mode to secure, as there
are no vlan table entries, but to use the port's destination
masks. Otherwise the switch won't forward anything.
* In read_status tell that the phy is up (taken from the rtl8306
driver).
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20083 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20082 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20079 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20075 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20074 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
ipw2x00 now depends on cfg80211 which is build form compat-wireless and not directly from kernel.
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20073 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
The patch commited in r18413 was wrong.
This patch prevents prom_init_mem from scanning over 128MB ram.
This is from #6765 and #3177
Refresh all patches
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20072 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20071 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20070 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20069 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20067 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20066 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20065 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20064 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20063 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20062 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20061 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20060 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20059 3c298f89-4303-0410-b956-a3cf2f4a3e73
|
|
git-svn-id: svn://svn.openwrt.org/openwrt/trunk@20057 3c298f89-4303-0410-b956-a3cf2f4a3e73
|