Use can_change_mtu() instead of hand-made function

[elmcan.git] / readme.rst

diff --git a/readme.rst b/readme.rst
index 23920d828885a8505b59918753a3df7619957a03..f05bb635f404e0427245a37f4fa59f2ca5a8edd8 100644 (file)
--- a/readme.rst
+++ b/readme.rst
@@ -4,7 +4,7 @@ Linux SocketCAN driver for ELM327
 Authors
 --------
 
-Max Staudt <elmcan@enpas.org>
+Max Staudt <max-linux@enpas.org>
 
 
 
@@ -26,7 +26,7 @@ This driver is an effort to turn abundant ELM327 based OBD interfaces
 into full-fledged (as far as possible) CAN interfaces.
 
 Since the ELM327 was never meant to be a stand-alone CAN controller,
-the driver has to switch between its modes asa quickly as possible in
+the driver has to switch between its modes as quickly as possible in
 order to approximate full-duplex operation.
 
 As such, elmcan is a best-effort driver. However, this is more than
@@ -43,6 +43,13 @@ known limitations in older controllers and clones.
 
 
 
+Requirements
+-------------
+
+This requires Linux 4.11 (for 431af779256c), and has been tested on 4.19.
+
+
+
 Data sheet
 -----------
 
@@ -308,9 +315,23 @@ Rationale behind the chosen configuration
 
 
 
+A note on CAN bus termination
+------------------------------
+
+Your adapter may have resistors soldered in which are meant to terminate
+the bus. This is correct when it is plugged into a OBD-II socket, but
+not helpful when trying to tap into the middle of an existing CAN bus.
+
+If communications don't work with the adapter connected, check for the
+termination resistors on its PCB and try removing them.
+
+
+
 To Do list for future development
 ----------------------------------
 
 - DMA capable rx/tx buffers
+  (is this relevant for this driver?)
 
 - flushing of ``tx_work`` is too late in ``ldisc_close()``
+  (is this still the case?)