case ATH79_SOC_AR7241:
case ATH79_SOC_AR9330:
case ATH79_SOC_AR9331:
+ case ATH79_SOC_QCA9533:
mdio_dev = &ath79_mdio1_device;
mdio_data = &ath79_mdio1_data;
break;
mdio_data->is_ar934x = 1;
break;
- case ATH79_SOC_QCA9558:
- if (id == 1)
- mdio_data->builtin_switch = 1;
- mdio_data->is_ar934x = 1;
+ case ATH79_SOC_QCA9533:
+ mdio_data->builtin_switch = 1;
break;
case ATH79_SOC_QCA9556:
+ case ATH79_SOC_QCA9558:
mdio_data->is_ar934x = 1;
break;
case ATH79_SOC_AR9341:
case ATH79_SOC_AR9342:
case ATH79_SOC_AR9344:
+ case ATH79_SOC_QCA9533:
case ATH79_SOC_QCA9556:
case ATH79_SOC_QCA9558:
pll_10 = AR934X_PLL_VAL_10;
case ATH79_SOC_AR7241:
case ATH79_SOC_AR9330:
case ATH79_SOC_AR9331:
+ case ATH79_SOC_QCA9533:
pdata->phy_if_mode = PHY_INTERFACE_MODE_MII;
break;
case ATH79_SOC_AR7241:
case ATH79_SOC_AR9330:
case ATH79_SOC_AR9331:
+ case ATH79_SOC_QCA9533:
pdata->phy_if_mode = PHY_INTERFACE_MODE_GMII;
break;
pdata->fifo_cfg3 = 0x01f00140;
break;
+ case ATH79_SOC_QCA9533:
+ if (id == 0) {
+ pdata->reset_bit = AR933X_RESET_GE0_MAC |
+ AR933X_RESET_GE0_MDIO;
+ pdata->set_speed = ath79_set_speed_dummy;
+
+ pdata->phy_mask = BIT(4);
+ } else {
+ pdata->reset_bit = AR933X_RESET_GE1_MAC |
+ AR933X_RESET_GE1_MDIO;
+ pdata->set_speed = ath79_set_speed_dummy;
+
+ pdata->speed = SPEED_1000;
+ pdata->duplex = DUPLEX_FULL;
+ pdata->switch_data = &ath79_switch_data;
+
+ ath79_switch_data.phy_poll_mask |= BIT(4);
+ }
+
+ pdata->ddr_flush = ath79_ddr_no_flush;
+ pdata->has_gbit = 1;
+ pdata->is_ar724x = 1;
+
+ if (!pdata->fifo_cfg1)
+ pdata->fifo_cfg1 = 0x0010ffff;
+ if (!pdata->fifo_cfg2)
+ pdata->fifo_cfg2 = 0x015500aa;
+ if (!pdata->fifo_cfg3)
+ pdata->fifo_cfg3 = 0x01f00140;
+ break;
+
case ATH79_SOC_QCA9556:
case ATH79_SOC_QCA9558:
if (id == 0) {
pdata->has_gbit = 1;
pdata->is_ar724x = 1;
+ /*
+ * Limit the maximum frame length to 4095 bytes.
+ * Although the documentation says that the hardware
+ * limit is 16383 bytes but that does not work in
+ * practice. It seems that the hardware only updates
+ * the lowest 12 bits of the packet length field
+ * in the RX descriptor.
+ */
+ pdata->max_frame_len = SZ_4K - 1;
+ pdata->desc_pktlen_mask = SZ_16K - 1;
+
if (!pdata->fifo_cfg1)
pdata->fifo_cfg1 = 0x0010ffff;
if (!pdata->fifo_cfg2)
case ATH79_SOC_AR7241:
case ATH79_SOC_AR9330:
case ATH79_SOC_AR9331:
+ case ATH79_SOC_QCA9533:
pdata->mii_bus_dev = &ath79_mdio1_device.dev;
break;