\end{Verbatim}
It is possible to use VLAN tagging on an interface simply by adding the VLAN IDs
-to it, e.g. \texttt{eth0.1}. These can be nested as well. See the switch section for
+to it, e.g. \texttt{eth0.15}. These can be nested as well. See the switch section for
this.
\begin{Verbatim}
-config inter
+config interface
+ option ifname "eth0.15"
+ option proto "none"
\end{Verbatim}
This sets up a simple static configuration for \texttt{eth0}. \texttt{proto} specifies the
\texttt{gateway} options are mandatory.
Leaving out the \texttt{netmask} option will turn the route into a host route.
-\subsubsection{Setting up the switch (currently broadcom only)}
+\subsubsection{Setting up the switch (broadcom only)}
The switch configuration is set by adding a \texttt{'switch'} config section.
Example:
You can then assign those interfaces to a custom network configuration name
like \texttt{lan}, \texttt{wan} or \texttt{dmz} for instance.
+\subsubsection{Setting up the switch (swconfig)}
+
+\emph{swconfig} based configurations have a different structure with one extra
+section per vlan. The example below shows a typical configuration:
+
+\begin{Verbatim}
+config 'switch' 'eth0'
+ option 'reset' '1'
+ option 'enable_vlan' '1'
+
+config 'switch_vlan' 'eth0_1'
+ option 'device' 'eth0'
+ option 'vlan' '1'
+ option 'ports' '0 1 2 3 5t'
+
+config 'switch_vlan' 'eth0_2'
+ option 'device' 'eth0'
+ option 'vlan' '2'
+ option 'ports' '4 5t'
+\end{Verbatim}
+
\subsubsection{Setting up IPv6 connectivity}
OpenWrt supports IPv6 connectivity using PPP, Tunnel brokers or static