+
+ /* Filter possible error messages based on length of RX'd line */
+ if (!_len_memstrcmp(elm->rxbuf, len, "UNABLE TO CONNECT")) {
+ netdev_err(elm->dev,
+ "ELM327 reported UNABLE TO CONNECT. Please check your setup.\n");
+ } else if (!_len_memstrcmp(elm->rxbuf, len, "BUFFER FULL")) {
+ /* This will only happen if the last data line was complete.
+ * Otherwise, elm327_parse_frame() will heuristically
+ * emit this kind of error frame instead.
+ */
+ frame->can_id |= CAN_ERR_CRTL;
+ frame->data[1] = CAN_ERR_CRTL_RX_OVERFLOW;
+ } else if (!_len_memstrcmp(elm->rxbuf, len, "BUS ERROR")) {
+ frame->can_id |= CAN_ERR_BUSERROR;
+ } else if (!_len_memstrcmp(elm->rxbuf, len, "CAN ERROR")) {
+ frame->can_id |= CAN_ERR_PROT;
+ } else if (!_len_memstrcmp(elm->rxbuf, len, "<RX ERROR")) {
+ frame->can_id |= CAN_ERR_PROT;
+ } else if (!_len_memstrcmp(elm->rxbuf, len, "BUS BUSY")) {
+ frame->can_id |= CAN_ERR_PROT;
+ frame->data[2] = CAN_ERR_PROT_OVERLOAD;
+ } else if (!_len_memstrcmp(elm->rxbuf, len, "FB ERROR")) {
+ frame->can_id |= CAN_ERR_PROT;
+ frame->data[2] = CAN_ERR_PROT_TX;
+ } else if (len == 5 && !_memstrcmp(elm->rxbuf, "ERR")) {
+ /* ERR is followed by two digits, hence line length 5 */
+ netdev_err(elm->dev, "ELM327 reported an ERR%c%c. Please power it off and on again.\n",
+ elm->rxbuf[3], elm->rxbuf[4]);
+ frame->can_id |= CAN_ERR_CRTL;
+ } else {
+ /* Something else has happened.
+ * Maybe garbage on the UART line.
+ * Emit a generic error frame.
+ */