2 * Copyright 2013 Gateworks Corporation
4 * The code contained herein is licensed under the GNU General Public
5 * License. You may obtain a copy of the GNU General Public License
6 * Version 2 or later at the following locations:
8 * http://www.opensource.org/licenses/gpl-license.html
9 * http://www.gnu.org/copyleft/gpl.html
16 model = "Gateworks Ventana i.MX6 Quad GW54XX";
17 compatible = "gw,imx6q-gw54xx", "gw,ventana", "fsl,imx6q";
19 /* these are used by bootloader for disabling nodes */
39 bootargs = "console=ttymxc1,115200";
43 reg = <0x10000000 0x40000000>;
47 compatible = "gpio-leds";
51 gpios = <&gpio4 6 0>; /* 102 -> MX6_PANLEDG */
53 linux,default-trigger = "heartbeat";
58 gpios = <&gpio4 7 0>; /* 103 -> MX6_PANLEDR */
59 default-state = "off";
64 gpios = <&gpio4 15 1>; /* 111 -> MX6_LOCLED# */
65 default-state = "off";
70 compatible = "simple-bus";
73 compatible = "regulator-fixed";
74 regulator-name = "1P0V";
75 regulator-min-microvolt = <1000000>;
76 regulator-max-microvolt = <1000000>;
81 compatible = "regulator-fixed";
82 regulator-name = "3P3V";
83 regulator-min-microvolt = <3300000>;
84 regulator-max-microvolt = <3300000>;
88 reg_usb_h1_vbus: usb_h1_vbus {
89 compatible = "regulator-fixed";
90 regulator-name = "usb_h1_vbus";
91 regulator-min-microvolt = <5000000>;
92 regulator-max-microvolt = <5000000>;
96 reg_usb_otg_vbus: usb_otg_vbus {
97 compatible = "regulator-fixed";
98 regulator-name = "usb_otg_vbus";
99 regulator-min-microvolt = <5000000>;
100 regulator-max-microvolt = <5000000>;
101 gpio = <&gpio3 22 0>;
107 compatible = "fsl,imx6q-sabrelite-sgtl5000",
108 "fsl,imx-audio-sgtl5000";
109 model = "imx6q-sabrelite-sgtl5000";
110 ssi-controller = <&ssi1>;
111 audio-codec = <&codec>;
113 "MIC_IN", "Mic Jack",
114 "Mic Jack", "Mic Bias",
115 "Headphone Jack", "HP_OUT";
122 pinctrl-names = "default";
123 pinctrl-0 = <&pinctrl_audmux_1>;
128 pinctrl-names = "default";
129 pinctrl-0 = <&pinctrl_flexcan1_1>;
134 pinctrl-names = "default";
135 pinctrl-0 = <&pinctrl_enet_1>;
137 phy-reset-gpios = <&gpio1 30 0>;
142 pinctrl-names = "default";
143 pinctrl-0 = <&pinctrl_gpmi_nand_2>;
148 clock-frequency = <100000>;
149 pinctrl-names = "default";
150 pinctrl-0 = <&pinctrl_i2c1_1>;
154 compatible = "atmel,24c02";
160 compatible = "atmel,24c02";
166 compatible = "atmel,24c02";
172 compatible = "atmel,24c02";
178 compatible = "nxp,pca9555";
185 compatible = "gw,gsp";
190 compatible = "dallas,ds1672";
196 clock-frequency = <100000>;
197 pinctrl-names = "default";
198 pinctrl-0 = <&pinctrl_i2c2_2>;
202 compatible = "fsl,pfuze100";
207 regulator-min-microvolt = <300000>;
208 regulator-max-microvolt = <1875000>;
211 regulator-ramp-delay = <6250>;
215 regulator-min-microvolt = <300000>;
216 regulator-max-microvolt = <1875000>;
219 regulator-ramp-delay = <6250>;
223 regulator-min-microvolt = <800000>;
224 regulator-max-microvolt = <3950000>;
230 regulator-min-microvolt = <400000>;
231 regulator-max-microvolt = <1975000>;
237 regulator-min-microvolt = <400000>;
238 regulator-max-microvolt = <1975000>;
244 regulator-min-microvolt = <800000>;
245 regulator-max-microvolt = <3300000>;
249 regulator-min-microvolt = <5000000>;
250 regulator-max-microvolt = <5150000>;
254 regulator-min-microvolt = <1000000>;
255 regulator-max-microvolt = <3000000>;
266 regulator-min-microvolt = <800000>;
267 regulator-max-microvolt = <1550000>;
271 regulator-min-microvolt = <800000>;
272 regulator-max-microvolt = <1550000>;
276 regulator-min-microvolt = <1800000>;
277 regulator-max-microvolt = <3300000>;
281 regulator-min-microvolt = <1800000>;
282 regulator-max-microvolt = <3300000>;
287 regulator-min-microvolt = <1800000>;
288 regulator-max-microvolt = <3300000>;
293 regulator-min-microvolt = <1800000>;
294 regulator-max-microvolt = <3300000>;
300 pciswitch: pex8609@3f {
301 compatible = "plx,pex8609";
305 pciclkgen: si52147@6b {
306 compatible = "sil,si52147";
312 clock-frequency = <100000>;
313 pinctrl-names = "default";
314 pinctrl-0 = <&pinctrl_i2c3_2>;
317 accelerometer: fxos8700@1e {
318 compatible = "fsl,fxos8700";
323 compatible = "fsl,sgtl5000";
325 clocks = <&clks 169>;
326 VDDA-supply = <&sw4_reg>;
327 VDDIO-supply = <®_3p3v>;
331 compatible = "adi,adv7611";
335 touchscreen: egalax_ts@04 {
336 compatible = "eeti,egalax_ts";
338 interrupt-parent = <&gpio7>;
339 interrupts = <12 2>; /* gpio7_12 active low */
340 wakeup-gpios = <&gpio7 12 0>;
343 videoout: adv7393@2a {
344 compatible = "adi,adv7393";
348 videoin: adv7180@20 {
349 compatible = "adi,adv7180";
355 pinctrl-names = "default";
356 pinctrl-0 = <&pinctrl_hog>;
359 pinctrl_hog: hoggrp {
361 MX6Q_PAD_EIM_D22__GPIO3_IO22 0x80000000 /* OTG_PWR_EN */
362 MX6Q_PAD_EIM_D19__GPIO3_IO19 0x80000000 /* SPINOR_CS0# */
363 MX6Q_PAD_ENET_TX_EN__GPIO1_IO28 0x80000000 /* PCIE IRQ */
364 MX6Q_PAD_ENET_TXD1__GPIO1_IO29 0x80000000 /* PCIE RST */
365 MX6Q_PAD_GPIO_0__CCM_CLKO1 0x000130b0 /* AUD4_MCK */
366 MX6Q_PAD_GPIO_2__GPIO1_IO02 0x80000000 /* CAN_STBY */
367 MX6Q_PAD_GPIO_17__GPIO7_IO12 0x80000000 /* TOUCH_IRQ# */
368 MX6Q_PAD_KEY_COL0__GPIO4_IO06 0x80000000 /* user1 led */
369 MX6Q_PAD_KEY_ROW0__GPIO4_IO07 0x80000000 /* user2 led */
370 MX6Q_PAD_KEY_ROW4__GPIO4_IO15 0x80000000 /* user3 led */
371 MX6Q_PAD_SD1_DAT0__GPIO1_IO16 0x80000000 /* USBHUB_RST# */
372 MX6Q_PAD_SD1_DAT3__GPIO1_IO21 0x80000000 /* MIPI_DIO */
381 crtcs = <&ipu1 0>, <&ipu1 1>, <&ipu2 0>, <&ipu2 1>;
386 reset-gpio = <&gpio1 29 0>;
389 eth1: sky2@8 { /* MAC/PHY on bus 8 */
390 compatible = "marvell,sky2";
391 /* Filled in by U-Boot */
392 mac-address = [ 00 00 00 00 00 00 ];
401 fsl,mode = "i2s-slave";
406 pinctrl-names = "default";
407 pinctrl-0 = <&pinctrl_uart1_2>;
412 pinctrl-names = "default";
413 pinctrl-0 = <&pinctrl_uart2_2>;
418 pinctrl-names = "default";
419 pinctrl-0 = <&pinctrl_uart3_1>;
424 pinctrl-names = "default";
425 pinctrl-0 = <&pinctrl_uart5_1>;
430 vbus-supply = <®_usb_otg_vbus>;
431 pinctrl-names = "default";
432 pinctrl-0 = <&pinctrl_usbotg_1>;
433 disable-over-current;
438 vbus-supply = <®_usb_h1_vbus>;
443 pinctrl-names = "default";
444 pinctrl-0 = <&pinctrl_usdhc3_2>;
445 cd-gpios = <&gpio7 0 0>;
446 vmmc-supply = <®_3p3v>;